I have seen tab brackets that install on a single valve cover bolt that hold the monitor harness in a p clip on quite a few engine monitor installations. Is there a spruce part number for these? Or just...
Brand new uncut Ashby glareshield - Part number 05-03878. Fits early 182 through to D model Small crack in the front eye brow that is easily fixable, Will try to post pic.
$160 US or $220 Can...
After flying my 182 for about a year and a half, I just couldn't stand the stench anymore. Almost thought I had an airsickness problem. I knew the plane had some mouse issues from the previous owner...
Replaced the old some what working radios with TKM units, but was pretty sick of the old ratty patched up panel and an Ipad on the yoke. Managed to do a center stack over the T- column. Only room for...
Looking at a possible new exhaust system for my 59 182B. Muffler was replaced about 5 years ago, but most joints are loose. Clamps tightened all the way over the years, vibration/heat cycling takes...
Have a Sigtronics 4 place sgi stereo intercom to replace my old sigtronics 2 place in my 182. Planning on starting the work in the next little while. I need wire for the rear jacks. 20 awg 3 conductor...
" Cessna 172 Winter Spoiler Mesh Wing and Tail Covers are the top choice for Arctic conditions.
Wind blows through the mesh.
Spoilers are sewn onto the leading edge in order to disrupt the air movement...
Just installed a new Lh bladder and at the same time installed the McFarland vent tube. My AME set the tube as per Cessna dimensions behind wing strut. Now with full tanks I can see fuel siphoning out...
Really looking at pulling the trigger on one of these two units very soon. I hear EI has the best customer support, but i am just looking at the price difference for two relatively similar units. Both...
Just swapped over my airglas fork to my 182. In resealing the strut I found what appears to be a teflon sleeve. Almost looked like someone added it in, but in researching the parts book. it is called...