Jeredp wrote:I installed aerofloor in a 182 last year. The install is easy. Go to the the local office depot and get some sheets of thick tagboard/poster board. I then cut them in to sections and taped it all together to make one large template. (cut the paper into strips and take advantage of all the the straight factory edges and just piece it all together; i.e., don't try to cut out a seatrack slot, take to strips and lay lengthwise with the track). After the template was cut, I laid it on the hanger floor over the top of the aerofloor and used very a very sharp knife and a 4 foot straight edge to make the cuts. The whole install was 2 hours at most. I then used 'industrial grade' velcro to attach it to the floor. In hind sight i should have framed every slot and edge with velcro, it was a tendency to curl where it is not heald down with velcro. The other thing I would do differently is used a gasket punch to make all the inside corners radiused to prevent them from tearing out.

denalipilot wrote:Corefile,
Thanks for sharing he Skandia foam link. I also felt that the 1/4" foam from SCS was excessive.
No reason why you couldn't apply the Skandia foam beneath CoinDot also, right?
-DP