Recently I purchased a nearby Bearhawk builder's entire project (4 place) as it no longer fit into his life. I don't need two sets of wings, plans, etc. so am selling the ones i got from him. Ribs, spars, flaps, ailerons, and wing steel are finished with Stits PolyFiber two part epoxy. His dad was an A&P, some incredibly nice workmanship. Included:

Wings were assembled on vertical jigs, one with skins clecoed in place
Aluminum for skinning second wing
Flaps and ailerons, assembled
Main and auxiliary tanks, all with gauge sending units installed and leak checks complete
Tank mounting straps
New fuel gauge and Facet transfer pumps
Cessna heated pitot tube and mast (used, tested)
Plans set
BH newsletters, beginning to 2008 (including the unobtainable 2001 - 2004 editions)
Extended reach BH bench dimpler

$5250 saves a lot of time, tedious work, and money.

Mark J
MN
218 three nine one 1844