Well, it was too cold to try spraying the engine with degreaser and scrubbing the cowling, so I went flying instead. I couldn't resist, it was CAVU, about 38F and as sunny as it gets and I haven't flown my new plane yet so I had to fly.
It was very strange, haven't flown in a year and I seem to be out of touch with the plane. It was probably a good thing I brought a CFI along for some brush up on technique and such. Anyway, the plane flew better than I did, although I need to adjust the rudder trim tab. Some dummy set it to provide left rudder trim, why someone would do this makes me wonder. This is the first 150 I have flown that stalled and dropped hard right and a good 80 degrees nose down from a power off stall. I know I was not doing a good job of keeping the ball centered, but I tell you, that was a serious eye opener...good thing its approved for spins.
In straight and level at 3500 FT and between 2450 and 2500 RPM it was indicating between 110 and 115 MPH, seemed high to me but I need more time to sort it out. The climb was awesome (for a 150 that is) today due to weather and low fuel load, it averaged about 600+ and I saw a sustained 1000 FPM for almost 45 seconds, if you can call that sustained.
The wife and I are going to go wash and wax it inside and out tomorrow and then hopefully top off the tanks for a relaxing afternoon flight. I just hope the $75 fuel bill doesn't give her sticker shock, or deter her from allowing me all the flying time we can afford. Maybe a nice sunrise flight to Montana will make her understand the irresistible draw that flight has for some of us.
N3110V