We do work on a lot of cool stuff here in Montana. They may not have flaps, but their still considered aircraft.
The last week or so I've been reassigned from the Cessna 180 to this UH-1H. The boss and I riveted these new T Caps in this morning.
There is one on either side of the aircraft, and they are a major structural component. The T cap runs from just forward of the lift beam -basically the front end of the forward "Hell Hole" aft to where the center deck makes it's angular transition upwards. (Aft end of the "Hell Hole") The forward two feet or so of the T cap can not be seen in the pictures. The T transitions to a flat section for the length of the forward "Hell Hole"
In the pictures, they are the yellow primed pieces. Quite a bit of disassembly required. The engine deck and side decks are removed. They are actually some pretty interesting composite panels with titanium top skin and aluminum honey comb inside.
The aft lH and RH Fuel lids are removed and the cells protected and taped over. (The bladders are pushed downward slightly out of the way) The AFt Center Fuel Bladder is removed.

The forward center white section that you see in this picture is where the transmission mounts, directly over the lift beam pictured.

The Center Deck and Engine are installed above this area.

The forward tailboom skins take a lot of heat and eventually have to be replaced. We riveted these new skins on Monday.
Tuesday I was back on a Cessna control surface and riveted up the rudder in the wooden box by the ladder.

The dark interior of a tailboom.





